INSTALLATION
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1. INSTALL HEATED OXYGEN SENSOR |
Temporarily tighten the heated oxygen sensor.
- NOTICE:
- Do not damage the heated oxygen sensor.
Using SST, fully tighten the heated oxygen sensor.

- SST
- 09224-00010
- Torque:
- 44 N*m{ 449 kgf*cm , 32 ft.*lbf }
- NOTICE:
- The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).
Connect the heated oxygen sensor connector.

