OPERATION CHECK
Troubleshooting · Vehicles built from Oct 2006
| CHECK ELECTRICAL DOOR LOCK OPERATION |
- NOTICE:
- The initial condition that the customizing function using the intelligent tester is not chosen is shown.
Check the basic function.
Check that all doors lock when the door control switch (for manual operation) is turned to LOCK and all doors unlock when turned to UNLOCK.
Check that all doors lock when the driver side door lock key cylinder is turned to LOCK using the mechanical key.
Check the electrical key lock-in prevention function (with Smart Entry and Start System).
- NOTICE:
- In order to prevent the electrical key from being actually locked-in, the following inspection should be performed with the driver side door window open.
Place the electrical key in the cabin.
With the driver side door open, turn the driver side door lock knob or door control switch to LOCK, and then close the driver side door. Then check that all doors unlock.
Check the key lock-in prevention function (without Smart Entry and Start System).
- NOTICE:
- In order to prevent the key from being actually locked-in, the inspection should be performed with the driver side door window open.
Have the key inserted into the ignition key cylinder.
With the driver side door open, check that all doors unlock immediately after the door lock knob for the driver side door is turned to LOCK.
With the driver side door open, check that all doors unlock immediately after the door control switch (for manual operation) is turned to LOCK.
With the driver side door open, turn the driver side door lock knob to LOCK, and then close the driver side door. Then check that all doors unlock.
Check the security function.
- HINT:
- *1: with Smart Entry and Start System
Close all doors with the driver side door window open so that the door control switch can be operated from outside the vehicle.
Remove the electrical key*1 or mechanical key (transmitter), open the driver side door and then close and lock the door using the electrical key*1 or mechanical key (transmitter). Under this condition, check that all doors do not unlock when the door control switch (for manual operation) is turned to UNLOCK from outside the vehicle.
Remove the electrical key *1 or the mechanical key, and close and lock the driver side door by mechanical key operation. Under this condition, check that all doors do not unlock when the door control switch (for manual operation) is turned to UNLOCK from outside the vehicle.
Remove the electrical key*1 or mechanical key (transmitter), close the driver side door, and lock the door by wireless door lock operation. Under this condition, check that all doors do not unlock when the door control switch (for manual operation) is turned to UNLOCK from outside the vehicle.
- HINT:
- Check that the security function is canceled under the following conditions:
- The ignition switch is turned on (IG).
- The driver side door is unlocked using the mechanical key (transmitter) or the electrical key.
- The door control switch (for manual operation) is turned to UNLOCK after the door control knob is turned to UNLOCK manually.
- The ignition switch is turned on (IG).
Check the illumination function.
Set the room light switch to the DOOR position.
With all doors locked, check that the driver's door unlocks when the driver side door lock cylinder is turned to UNLOCK using the key. At the same time, the room light comes on.
Check that the room light goes off in approximately 15 seconds if the doors have not been opened.
Check the AUTO lock function (with Smart Entry and Start System).
Lock all doors.
Unlock the driver's door using the electrical key.
Allow 30 seconds to elapse while all doors remain closed and the electrical key switch and the entry unlock switch remain untouched. Then, check that all doors will lock automatically.