REASSEMBLY
Removal / installation · Vehicles built from Jun 2006
| 1.
INSTALL BRAKE ACTUATOR |
 |
- Install the brake actuator horizontally into position on the brake actuator bracket assembly.
- NOTICE:
- Do not remove the hole plug before installing a new brake actuator because the brake actuator assembly is filled with brake fluid.
Temporarily install the bolt vertically through the cushion and into the brake actuator.
- Install the 2 nuts and fully tighten the bolt.
-
Torque:
- Bolt:
- 4.7 N*m{
48 kgf*cm
, 42 in.*lbf
}
- Nut:
- 8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}