The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
INSPECTION PROCEDURE
| 1. CHECK CELLULAR PHONE |
 |
Check if the other caller can hear your voice correctly.
- OK:
- Your voice can be heard correctly.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK SETTINGS |
 |
Enter the "Call" screen.
- Check if the "Mute" switch is not set to on.
- OK:
- "Mute" switch is not set to on.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK MICROPHONE (OPERATION CHECK) |
 |
- Enter the "Microphone&Voice Recognition Check" screen (Check Mic & Voice Recognition) (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
- HINT:
- Voice can be recorded up to 5 seconds.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
- OK:
- All check results are normal.
- Result:
Result
|
Proceed to
|
NG
|
A
|
OK (for 2GR-FE RHD)
|
B
|
OK (except 2GR-FE RHD)
|
C
|
Text in Illustration
*1
|
Microphone Input Level Meter
|
*2
|
Recording Switch
|
*3
|
Stop Switch
|
*4
|
Play Switch
|
*5
|
Recording Indicator
|
|
B |
 |
|
| REPLACE NAVIGATION RECEIVER ASSEMBLY (for 2GR-FE RHD) (Click here)
|
|
|
|
C |
 |
|
| REPLACE NAVIGATION RECEIVER ASSEMBLY (except 2GR-FE RHD) (Click here)
|
|
|
| A |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|