ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT CLOCK ASSEMBLY |
Disconnect the F3 connector.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
F3-1 (B) - Body ground
Always
10 to 14 V
F3-2 (ACC) - Body ground
Ignition switch off
Below 1 V
Ignition switch on (IG)
10 to 14 V
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
F3-19 (GND1) - Body ground
Always
Below 1 Ω
- HINT:
- If the value is not as specified, repair or replace the wire harness or connector.
