Install the No. 2 shift cable grommet retainer to the transmission control cable assembly.
Install the control cable assembly through the floor hole.
Install the control cable assembly with the 2 bolts.
Torque:
5.0 N*m{
51 kgf*cm
, 44 in.*lbf
}
Connect the ends of the 2 cables and install the 2 washers and 2 clips.
Install 2 new clips to the control cable bracket.
2.
INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
Connect the control cable to the shift lever retainer.
NOTICE:
The projecting part of the cable outer should face upward when the shift cable is connected.
After installation, make sure that the cable outer lock is projecting from A as shown in the illustration.
Connect the end of the shift cable to the shift lever assembly with the clip.
Connect the end of the select cable to the shift lever assembly with a new clip.
NOTICE:
The serrated part of the select cable point should face upward when the select cable point is connected.
The clip should be installed in the direction as shown in the illustration.
3.
INSTALL CENTER AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the battery negative (-) cable is disconnected.
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
Install the center airbag sensor assembly with the 3 bolts.
Torque:
17.5 N*m{
179 kgf*cm
, 13 ft.*lbf
}
NOTICE:
If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
Check that there is no looseness in the installation parts of the center airbag sensor assembly.