2006-2011 Camry Aurion · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. PRECAUTION

HINT:
Click here.


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE AIR CONDITIONER UNIT ASSEMBLY
Click here.

4. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY

  1. C132951
    Remove the 2 clips and disconnect the end of the transmission control cable.

  1. C135402E01
    Pull out the control cable assembly locks.

  1. C132953
    Turn the adjust nut 180° clockwise. While holding the adjust nut, separate the control cable assembly.


5. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
  1. Turn back the carpet.

  1. C133884
    Disconnect the holder (with connectors).

  1. Remove the 3 bolts and center airbag sensor assembly.


6. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

  1. A134904
    Remove the 2 nuts and cover.


7. REMOVE AIR CLEANER INLET ASSEMBLY

  1. A134903
    Remove the 2 bolts, clamp and air cleaner inlet.


8. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A144946E01
    Disconnect the mass air flow meter connector (*1).

  1. Disconnect the purge VSV connector (*2).

  1. Disconnect the 2 purge VSV vacuum hoses (*3).

  1. Disconnect the purge line hose from the clamp (*4).

  1. A146036
    Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. A135668
    Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.

  1. A146037
    Remove the 2 bolts and air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


9. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

  1. A134905
    Disconnect the hose clamp.

  1. Remove the 3 bolts and air cleaner case.


10. REMOVE BATTERY

  1. A134906
    Loosen the bolt and nut, and remove the battery clamp.

  1. Remove the battery and battery tray.


11. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

  1. C132952
    Remove the 2 clips and 2 washers and disconnect the 2 cables from the transaxle.

  1. Remove the 2 clips and disconnect the 2 cables from the control cable bracket.

  1. C135401
    Remove the 2 bolts and control cable assembly.

  1. Remove the No. 2 shift cable grommet retainer from the control cable assembly.

← REMOVAL (Oct 2006 – May 2009)INSTALLATION (Jun 2006 – Sep 2006) →