2006-2011 Camry Aurion · Service Manual TRANSMISSION

P0798 Pressure Control Solenoid "C" Electrical (Shift Solenoid Valve SL3)

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

Shifting gears from 1st through 5th is performed in combination with "ON" and "OFF" operation of the shift solenoid valves SL1, SL2, SL3 and SL4 which are controlled by the TCM. If an open or short circuit occurs in any of the shift solenoid valves, the TCM controls the remaining normal shift solenoid valves to allow the vehicle to be operated smoothly (Fail safe function).
DTC No.
DTC Detection Condition
Trouble Area
P0798
The TCM checks for an open or short in the shift solenoid valve SL3 circuit while driving and shifting gears.
(1-trip detection logic)
  1. Output signal duty equals to 100%.
(NOTE: SL3 output signal duty is less than 100% under normal condition.)
  1. Open or short in shift solenoid valve SL3 circuit
  2. Shift solenoid valve SL3
  3. TCM

MONITOR DESCRIPTION

The TCM commands gear shifts by turning the shift solenoid valves on or off. When there is an open or short circuit in any shift solenoid valve circuit, the TCM detects the problem, illuminates the MIL and stores the DTC. The TCM performs the fail-safe function and turns the other normal shift solenoid valves on or off. (In case of an open or short circuit, the TCM stops sending current to the circuit.)
(Click here)

WIRING DIAGRAM

C133261E10

INSPECTION PROCEDURE


1. INSPECT TRANSMISSION WIRE (SL3)

  1. C133212E05
    Remove the TCM from the transaxle.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    16 (SL3+) - 15 (SL3-)
    5.0 to 5.6 Ω
    (at 20°C (68°F))

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    16 (SL3+) - Body ground
    10 kΩ or higher
    15 (SL3-) - Body ground
    10 kΩ or higher



OK
REPLACE TCM
NG


2. INSPECT SHIFT SOLENOID VALVE (SL3)

  1. G020767E29
    Remove the shift solenoid valve SL3.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    5.0 to 5.6 Ω
    (at 20°C (68°F))

  1. Connect a positive (+) lead through a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.

    OK:
    The solenoid makes an operating sound.



NG
REPLACE SHIFT SOLENOID VALVE (SL3)
OK

REPLACE TRANSMISSION WIRE


← P0796 Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3) (from Jun 2009)P0872 Transmission Fluid Pressure Sensor / Switch "C" Circuit Low (+ P0873) (from Oct 2006) →