ADJUSTMENT
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
| 1. INSPECT SHIFT LEVER POSITION |
When shifting from the P to the R position with the ignition switch on (IG) and brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.
Start the engine and make sure that the vehicle moves forward when shifting from the N to the D position and moves rearward when shifting to the R position.
If operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.
| 2. ADJUST SHIFT LEVER POSITION |
Move the shift lever to the N position.
Remove the nut from the control shaft lever.

Disconnect the transmission control cable assembly from the control shaft lever.
Push the control shaft lever fully downward.

Return the control shaft lever 2 notches to the N position.
Move the slider in the direction indicated by arrow A and pull up the lock piece in the direction indicated by arrow B.

- NOTICE:
- Do not damage the boot.
Install the transmission control cable to the control shaft lever with the nut.

- Torque:
- 15 N*m{ 148 kgf*cm , 11 ft.*lbf }
- NOTICE:
- If the control cable end is excessively pushed up, the shift lever cannot be adjusted.
- When tightening the nut, confirm that the control cable is properly stretched.
- If the control cable end is excessively pushed up, the shift lever cannot be adjusted.
Push in the lock piece.

- NOTICE:
- Firmly push in the lock piece until the slider lock is engaged.
- HINT:
- After pushing the lock piece make sure that the boot is not deformed.
Start the engine and make sure that the vehicle moves forward when moving the shift lever from the N to the D position and moves rearward when moving it to the R position.
If it becomes hard to move the shift lever, readjust the shift lever position.
