2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jun 2006


INSPECT HEADLIGHT LEVELING SWITCH

  1. E133257E02
    Measure the voltage of the switch.

    1. Remove the headlight leveling switch.

    2. Apply battery voltage to the headlight leveling switch connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage:
      Measurement Condition
      Tester Connection
      Switch Condition
      Specified Condition
      (Battery voltage is 12 V)
      Battery positive (+) → Terminal 1 (B)
      Battery negative (-) → Terminal 4 (E)
      2 (T) - 4 (E)
      0
      10.5 to 11.1 V
      (0.5)
      9.5 to 10.1 V
      1
      8.6 to 9.1 V
      (1.5)
      7.7 to 8.2 V
      2
      6.8 to 7.2V
      (2.5)
      5.8 to 6.2 V
      3
      4.9 to 5.2 V
      (3.5)
      4.0 to 4.2 V
      4
      3.0 to 3.2 V
      (4.5)
      2.1 to 22 V
      5
      1.1 to 1.3 V

      If the result is not as specified, replace the headlight leveling switch.

  1. Inspect the illumination of the switch.

    1. Apply battery voltage to the headlight leveling switch connector.

    2. Check that the illumination comes on.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (ILL+)
      Battery negative (-) → Terminal 4 (E)
      Illumination comes on

      If the result is not as specified, replace the headlight leveling switch.

← INSTALLATION (from Jun 2009)COMPONENTS (from Oct 2006) →