1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2.
REMOVE ENGINE UNDER COVER RH
3.
REMOVE ENGINE UNDER COVER LH
4.
DRAIN ENGINE COOLANT
NOTICE:
Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Remove the radiator cap sub-assembly from the radiator assembly.
Loosen the radiator drain cock plug and cylinder block drain cock plug, then drain the coolant.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
5.
REMOVE FRONT FENDER APRON SEAL RH
6.
REMOVE NO. 2 ENGINE MOUNTING STAY RH
Remove the 2 bolts and No. 2 engine mounting stay RH.
7.
REMOVE ENGINE MOVING CONTROL ROD SUB-ASSEMBLY
Remove the bolt and disconnect the ground cable.
Remove the 3 bolts and engine moving control rod sub-assembly.
8.
REMOVE NO. 2 ENGINE MOUNTING BRACKET RH
Remove the 3 bolts and No. 2 engine mounting bracket RH.
9.
REMOVE V-RIBBED BELT
Using SST and a 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.
SST
09216-42010
NOTICE:
Be sure to connect SST and the tools so that they are in line during use.
When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
After the tensioner is fully retracted, do not apply more force than necessary.
10.
REMOVE GENERATOR ASSEMBLY
Disconnect the generator connector.
Remove the nut and disconnect the wire harness from terminal B.
Remove the bolt and wire harness clamp bracket.
Remove the wire harness clamp.
Remove the 2 bolts and generator assembly.
11.
REMOVE WATER PUMP PULLEY
Using SST, remove the 4 bolts and water pump pulley.
SST
09960-10010
(09962-01000, 09963-00700)
12.
REMOVE WATER PUMP ASSEMBLY
Remove the clamp of the crankshaft position sensor from the water pump.
Disconnect the wire of the crankshaft position sensor from the clamp bracket.
Remove the 4 bolts, 2 nuts and clamp bracket.
Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.
HINT:
Tape the screwdriver tip before use.
NOTICE:
Be careful not to damage the contact surfaces of the water pump and cylinder block.