Circuit diagnosis · Vehicles built Jun 2006 – May 2009
Versions by build date: Jun 2006 – May 2009from Jun 2009
DESCRIPTION
When the low beam headlights are on, and the dimmer switch is turned to the HIGH position, the main body ECU turns the high beam headlights on.
HINT:
When a short circuit occurs between the power distributor and high beam headlight, the power distributor stops the high beam headlight relay operation (Fail-safe function).
The high beam headlight relay is built into the power distributor, so unlike conventional relays, it cannot be removed for inspection.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Select the item below in the ACTIVE TEST and then check that the relay operates.
Main Body (Main Body ECU):
Tester Display
Test Part
Control Range
Diagnostic Note
Headlight (HI)
High beam headlights
ON / OFF
-
OK:
High beam headlight relay operates. (High beam headlights illuminate.)
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE