2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Air Conditioning Amplifier Communication Stop Mode

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
Air Conditioning Amplifier Communication Stop Mode
  1. "Air Conditioner" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Air Conditioning Amplifier Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the air conditioning amplifier
  2. Air conditioning amplifier branch wire or connector
  3. Air conditioning amplifier

HINT:
"Air Conditioner" refers to the circuit that includes the air conditioning amplifier.


WIRING DIAGRAM

C133239E07

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN NO. 1 BUS WIRE (AIR CONDITIONING AMPLIFIER BRANCH WIRE)

  1. E124470E21
    Turn the engine switch off.

  1. Disconnect the air conditioning amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E38-11 (CANH) - E38-12 (CANL)
    Engine switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN NO. 1 BUS MAIN WIRE OR CONNECTOR (AIR CONDITIONING AMPLIFIER BRANCH WIRE)
OK


2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

  1. E124470E22
    Disconnect the air conditioning amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E38-14 (GND) - Body Ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E38-1 (IG+) - Body Ground
    Engine switch on (IG)
    10 to 14 V
    E38-21 (B) - Body Ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER


← Skid Control ECU Communication Stop Mode (from Oct 2006)Gateway ECU Communication Stop Mode (Oct 2006 – May 2009) →