2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Main Body ECU Communication Stop Mode

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
Main Body ECU Communication Stop Mode
  1. "Main Body" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Main Body ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the main body ECU
  2. Main body ECU branch wire or connector
  3. Main body ECU

WIRING DIAGRAM

C142796E02

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN main wires and CAN branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK CAN BUS LINE FOR DISCONNECTION (MAIN BODY ECU BRANCH WIRE)

  1. B137983E02
    Turn the ignition switch off.

  1. Disconnect the main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E8-5 (CANH) - E8-6 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO MAIN BODY ECU (CAN-H, CAN-L)
OK


2. CHECK HARNESS AND CONNECTOR (IG, GND1)

  1. C133238E02
    Disconnect the IF J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    IF-10 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    IF-11 (IG) - Body ground
    Ignition switch on
    10 to 14 V

  1. Reconnect the main body ECU connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← ECM Communication Stop Mode (Jun 2006 – Sep 2006)Combination Meter ECU Communication Stop Mode (Jun 2006 – Sep 2006) →