HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
- HINT:
- Use the following procedure to troubleshoot the engine immobiliser system.
- The intelligent tester should be used in steps 3, 4, and 6.
- Use the following procedure to troubleshoot the engine immobiliser system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CRANK ENGINE FOR MORE THAN 10 SECONDS |
| |||||
| 3.CHECK FOR DTCS |
Check for DTCs and note any codes that are output.
Delete the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to duplicate the SFI system DTC or engine immobiliser system DTC by simulating the symptoms indicated by the DTC.
- Result:
Result
Proceed to
DTC output does not reoccur
A
SFI system DTC output reoccurs
B
(Click here for 2AZ-FE)
(Click here for 2GR-FE)
Engine immobiliser system DTC output reoccurs
C
(Click here)
|
|||||
|
|||||
| |||||
| 4.READ VALUE ON INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.

Turn the ignition switch to the ON position and turn the intelligent tester on.
Read the DATA LIST according to the display on the tester.
IMMOBILISER: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal/ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-
- OK:
- ON (Key is in ignition key cylinder) appears on the screen.
|
|||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
If the fault is not listed in the problem symptoms table, proceed to A.
If the fault is listed in the problem symptoms table, proceed to B.
|
|||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING |
DATA LIST / ACTIVE TEST (Click here)
TERMINALS OF ECU (Click here)
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
| |||||