ECU Power Source Circuit
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This circuit provides power to operate the transponder key ECU assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
| 1. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY) |
 |
- Disconnect the E15 ECU connector.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
|
Condition
|
Specified Condition
|
E15-1 (+B) - Body ground
|
Always
|
10 to 14 V
|
E15-2 (IG) - Body ground
|
Ignition switch OFF
|
Below 1 V
|
Ignition switch ON
|
10 to 14 V
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE |
|
|
| OK |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BODY GROUND) |
 |
- Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
E15-16 (GND) - Body ground
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|