B2796 No Communication in Immobiliser System
Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009
Also covers:
- B2798 Communication Malfunction No. 2
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
These DTCs are output if a key that does not have a transponder chip is inserted into the ignition key cylinder or if communication between the key and transponder key ECU assembly is impossible.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2796 |
The key code cannot be transmitted |
|
| B2798 |
Key code identification cannot be completed within the specified time (15 to 50 ms) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
- If the key is replaced, register the key.
- If the key is replaced, register the key.
| 1. READ VALUE ON INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.

Turn the ignition switch to the ON position and turn the intelligent tester on.
Select Immobiliser in the DATA LIST and read the intelligent tester display.
IMMOBILISER: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Immobiliser
Immobiliser system status/SET or UNSET
UNSET: Ignition switch ON
SET: Without key
-
- OK:
- UNSET (Ignition switch ON) appears on the screen.
|
|
||||
| NG | |
| 2. CHECK KEYS |
Insert the vehicle's other key into the ignition key cylinder.
Check that the engine starts with this key.
- OK:
- The engine starts.
|
|
||||
| NG | |
| 3. CHECK TRANSPONDER KEY AMPLIFIER |
After replacing the transponder key amplifier (Click here) with a normally functioning amplifier, check that the engine starts.
- OK:
- The engine starts.
|
|
||||
| OK | ||
| ||
