When an additional transponder key is registered, the transponder key ECU assembly detects the front door courtesy light switch open/close condition, and enters the key registration mode.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
1. CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH CIRCUIT)
Disconnect the E15 ECU connector.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
E15-7 (CTY) - Body ground
Courtesy switch pushed (Door closed)
10 kΩ or higher
Courtesy switch free (Door open)
Below 1 Ω
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
NG
2. INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
Remove the driver side front door courtesy light switch (Click here).
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
1 - Switch body
Courtesy switch pushed (Door closed)
10 kΩ or higher
Courtesy switch free (Door open)
Below 1 Ω
NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (Click here)
OK
REPAIR OR REPLACE HARNESS OR CONNECTOR (TRANSPONDER KEY ECU - FRONT DOOR COURTESY LIGHT SWITCH)