B2799 Engine Immobiliser System Malfunction
Diagnostic trouble codes · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This DTC is output when the ECM detects errors in communication with the transponder key ECU and in the communication lines.This DTC is also output when an engine start is attempted while the ECU communication ID between the transponder key ECU and the ECM is different.
Before troubleshooting for this DTC, make sure that there is no DTC detected in the transponder key ECU. If there is any key code related DTC detected in the transponder key ECU, repair it first.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2799 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
- If the ECM is replaced, register the ECU communication ID.
- If the ECM is replaced, register the ECU communication ID.
| 1. RE-REGISTER ECU COMMUNICATION ID |
Re-register the ECU communication ID between the transponder key ECU assembly and ECM.
Check that the engine starts.
- OK:
- The engine starts.
|
|
||||
| NG | |
| 2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM) |
Disconnect the E15 ECU and A24 ECM connectors.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E15-12 (EFII) - A24-10 (IMO)
Always
Below 1 Ω
E15-13 (EFIO) - A24-11 (IMI)
E15-12 (EFII) - Body ground
10 kΩ or higher
E15-13 (EFIO) - Body ground
|
|
||||
| OK | |
| 3. REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 4. REGISTER ECU COMMUNICATION ID |
Re-register the ECU communication ID between the transponder key ECU assembly and ECM.
Check that the engine starts.
- OK:
- The engine starts.
|
|
||||
| OK | ||
| ||
