2006-2011 Camry Aurion · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. DRAIN ENGINE COOLANT

2. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A140800
    Hold the front of the V-bank cover and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.


3. REMOVE FRONT FENDER APRON SEAL RH

4. REMOVE NO. 2 B ENGINE MOUNTING STAY RH

  1. A132985
    Remove the bolt, 2 nuts, and No. 2 B engine mounting stay RH.


5. REMOVE ENGINE MOVING CONTROL ROD SUB-ASSEMBLY

  1. A132986
    Remove the 4 bolts and engine moving control rod.


6. REMOVE V-RIBBED BELT

  1. A129622E01
    Using SST, release the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.
    SST
    09249-63010  

  1. A095070
    While turning the belt tensioner counterclockwise, align with its holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner.


7. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

  1. A129645E03
    Remove the bolts, plates and No. 2 idler pulley sub-assemblies.


8. DISCONNECT RADIATOR HOSE OUTLET

  1. A133364
    Disconnect the radiator outlet hose from the radiator assembly.


9. REMOVE WATER INLET

  1. A133374
    Remove the 2 nuts and water inlet.


10. REMOVE THERMOSTAT
  1. Remove the gasket from the thermostat.

← REMOVAL (Oct 2006 – May 2009)INSPECTION (from Oct 2006) →