2006-2011 Camry Aurion · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. INSTALL RADIATOR TANK UPPER

  1. A104624E02
    Install the punch assembly to the overhaul handle, inserting it in the hole in part A as shown in the illustration.
    SST
    09230-01010  
    09231-14010  

  1. While gripping the handle, adjust the stopper bolt so that dimension B is as shown in the illustration.

    Dimension B:
    8.4 mm (0.331 in.)

  1. A104623E03
    After checking that there are no foreign objects in the lock plate groove, install a new O-ring without twisting it.

    HINT:
    When cleaning the lock plate groove, lightly rub it with sandpaper without scratching it.

  1. A128141E01
    Install the tank without damaging the O-ring.

  1. Tap the lock plate with a soft-faced hammer so that there is no gap between the lock plate and the tank.

  1. A129608E01
    Lightly press SST against the lock plate in the order shown in the illustration. After repeating this a few times, fully caulk the lock plate by gripping the handle until stopped by the stopper plate.

  1. A144993
    Do not tap the areas protruding around the pipes, brackets or tank ribs.

  1. A144994
    Do not tap the area indicated by the circle in the illustration. For the areas where cannot be tapped with the SST, use pliers or similar objects and be careful not to damage the core plates.

  1. A128142E02
    Check the lock plate height (H) after completing caulking.

    Plate height (H):
    7.40 to 7.80 mm (0.2913 to 0.3071 in.)

    If not within the specified height range, adjust the stopper bolt of the handle and caulk again.


2. INSTALL RADIATOR TANK LOWER
  1. Installation procedure of the lower radiator tank is the same as that of the upper radiator tank.

  1. A134968E08
    Install the hose with the bolt and 2 clips.

    Torque:
    15 N*m{ 150 kgf*cm , 11 ft.*lbf }


3. INSTALL DRAIN PLUG
  1. Install a new O-ring to the drain plug.

  1. Install the drain plug.


4. INSPECT FOR WATER LEAK

  1. A128143E03
    Plug the inlet and outlet pipes of the radiator with SST.
    SST
    09230-01010  

  1. Using the radiator cap tester, apply pressure to the radiator.

    Test pressure:
    177 kPa (1.8 kgf/cm2, 26 psi)

  1. Submerge the radiator in water.

  1. A087096E02
    Inspect for leaks.

    HINT:
    On radiators with resin tanks, there is clearance between the tank and lock plate where a minute amount of air will remain, giving the appearance of an air leak when the radiator is submerged in water. Therefore, before doing the water leak test, first swish the radiator around in the water until all air bubbles disappear.

← INSPECTION (from Jun 2006)INSTALLATION (Jun 2006 – Sep 2006) →