2006-2011 Camry Aurion · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2006


INSPECT OIL PUMP RELIEF VALVE

  1. A094628
    Coat the relief valve with engine oil and check that it falls smoothly into the valve hole under its own weight.
    If the valve does not fall smoothly, replace the relief valve. If necessary, replace the oil pump assembly.


INSPECT OIL PUMP ROTOR SET

  1. A128010E01
    Install the rotors to the timing chain cover with the rotors' marks facing outward. Check that the rotors rotate smoothly.

  1. A128011
    Check the tip clearance.

    1. Using a feeler gauge, measure the clearance between the drive and driven rotors, as shown in the illustration.

      Tip clearance:
      Standard
      Maximum
      0.060 to 0.160 mm (0.0024 to 0.0063 in.)
      0.16 mm (0.0063 in.)

      If the clearance is greater than the maximum, replace the drive and driven rotors.

  1. A128012
    Check the side clearance.

    1. Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge, as shown in the illustration.

      Side clearance:
      Standard
      Maximum
      0.030 to 0.090 mm (0.0012 to 0.0035 in.)
      0.090 mm (0.0035 in.)

      If the side clearance is greater than the maximum, replace the timing chain cover.

  1. A128013
    Check the body clearance.

    1. Using a feeler gauge, measure the clearance between the timing chain cover and driven rotor, as shown in the illustration.

      Body clearance:
      Standard
      Maximum
      0.250 to 0.325 mm (0.0098 to 0.0128 in.)
      0.325 mm (0.0128 in.)

      If the body clearance is greater than the maximum, replace the timing chain cover.

← DISASSEMBLY (from Oct 2006)REASSEMBLY (from Oct 2006) →