2006-2011 Camry Aurion · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE

  1. A136023E01
    Install a new gasket to the fuel suction tube.

  1. Install the fuel suction tube.

    NOTICE:
    1. Do not damage the fuel pump filter.
    2. Be careful that the arm of the sender gauge does not bend.


2. INSTALL FUEL TANK VENT TUBE SET PLATE

  1. A129480E01
    Align the mark of the set plate with the fuel suction tube.

  1. Install the set plate with the 8 bolts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }


3. CONNECT FUEL PUMP TUBE SUB-ASSEMBLY

  1. A139189E01
    Install the fuel pump tube with the tube joint clip.

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting part.
    2. Check that the fuel tube joint is inserted securely.
    3. Check that the tube joint clip is on the collar of the fuel tube joint.
    4. After installing the tube joint clip, check that the fuel tube joint cannot be pulled off.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. INSTALL REAR FLOOR SERVICE HOLE COVER

  1. A129478
    Connect the fuel pump connector.

  1. Install the rear floor service hole cover with new butyl tape.


6. INSPECT FOR FUEL LEAK

HINT:
Click here.


7. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Type)

  1. B140589E01
    Attach the 2 front hooks of the seat cushion to the vehicle body.

  1. Confirm that the seat cushion is firmly installed.

    NOTICE:
    When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.


8. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)

  1. B140584E01
    Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.

  1. Confirm that the seat cushion is firmly installed.

    NOTICE:
    When installing the bench type rear seat cushion assembly, make sure that the seat belt buckle is not under the bench type rear seat cushion assembly.

← INSTALLATION (Jun 2006 – May 2009)COMPONENTS (from Jun 2006) →