DISASSEMBLY
Removal / installation · Vehicles built from Oct 2006
| 1.
REMOVE NO. 2 FUEL SUCTION SUPPORT |
 |
- Using a screwdriver with its tip wrapped with tape, disengage the 5 snap claws from the claw holes, and remove the No. 2 fuel suction support.
- NOTICE:
- Do not damage the fuel suction support.
| 2.
REMOVE FUEL PUMP CUSHION RUBBER |
 |
- Remove the fuel pump cushion rubber from the fuel pump.
| 3.
REMOVE FUEL SENDER GAUGE ASSEMBLY |
 |
- Disconnect the fuel sender gauge connector (*1).
Unlock the fuel sender gauge, and slide it to remove (*2).
| 4.
REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY |
 |
- Disconnect the fuel pump connector (*1).
Using a screwdriver with its tip wrapped with tape, disengage the 4 snap claws from the claw holes, and pull out the fuel suction plate.
- NOTICE:
- Do not damage the fuel suction support.
| 5.
REMOVE FUEL PUMP HARNESS |
 |
- Disconnect the connector (*1).
Using a screwdriver, pry out the fuel pump harness (*2).
| 6.
REMOVE FUEL PUMP |
 |
- Pull out the fuel pump from the fuel filter.
| 7.
REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
 |
- Pull out the fuel pressure regulator from the fuel filter.
- Remove the O-ring from the fuel pressure regulator.