LVL Terminal Circuit
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
- By connecting terminals LVL and CG of the DLC3, the AFS ECU or headlight leveling ECU initializes the height control sensor signal.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT DLC3 TERMINAL VOLTAGE |
 |
- Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
|
Condition
|
Specified Condition
|
E10-8 (LVL) - Body ground
|
Ignition switch on (IG)
|
10 to 14 V
|
E10-8 (LVL) - Body ground
|
Ignition switch off
|
Below 1 V
|
|
OK |
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|
|
| NG |
|
 |
|
| 2. CHECK VEHICLE CONDITION |
 |
- Result:
Condition
|
Proceed to
|
without AFS
|
A
|
with AFS
|
B
|
|
B |
 |
|
|
|
| A |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT LEVELING ECU AND BODY GROUND) |
 |
- Disconnect the A20 headlight leveling ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A20-5 (SPDL) - E10-8 (LVL)
|
Always
|
Below 1 Ω
|
A20-5 (SPDL) - Body ground
|
Always
|
10 kΩ or higher
|
E10-4 (CG) - Body ground
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| REPLACE HEADLIGHT LEVELING ECU ASSEMBLY |
|
| 4. CHECK HARNESS AND CONNECTOR (DLC3 - AFS ECU AND BODY GROUND) |
 |
- Disconnect the A61 AFS ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A61-7 (AFWG) - E10-8 (LVL)
|
Always
|
Below 1 Ω
|
A61-7 (AFWG) - Body ground
|
Always
|
10 kΩ or higher
|
E10-4 (CG) - Body ground
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
|