DISASSEMBLY
Removal / installation · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
| 1.
REMOVE FRONT DRIVE SHAFT LH HOLE SNAP RING |
 |
- Using a screwdriver, remove the front drive shaft LH hole snap ring.
| 2.
REMOVE NO. 2 FRONT AXLE INBOARD JOINT BOOT CLAMP |
 |
- Using needle-nose pliers, remove the No. 2 front axle inboard joint boot clamp as shown in the illustration.
| 3.
REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP |
 |
- Using pliers, remove the front axle inboard joint boot clamp as shown in the illustration.
| 4.
SEPARATE FRONT AXLE INBOARD JOINT BOOT |
 |
Separate the front axle inboard joint boot from the inboard joint assembly.
| 5.
REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY |
 |
Remove the grease from the inboard joint assembly.
- Put matchmarks on the inboard joint assembly and outboard joint shaft.
- NOTICE:
- Do not use a punch for the marks.
Remove the inboard joint assembly from the outboard joint shaft.
- Using a snap ring expander, remove the shaft snap ring.
- Put matchmarks on the outboard joint shaft and tripod joint.
- NOTICE:
- Do not use a punch for the marks.
Using a brass bar and a hammer, remove the tripod joint from the outboard joint shaft.
- NOTICE:
- Do not tap the roller.
| 6.
REMOVE FRONT AXLE INBOARD JOINT BOOT |
 |
Remove the inboard joint boot from the outboard joint shaft.
| 7.
REMOVE FRONT DRIVE SHAFT DAMPER LH (for Automatic Transaxle) |
 |
- Using pliers, remove the drive shaft damper clamp as shown in the illustration.
Remove the drive shaft damper.
| 8.
REMOVE FRONT DRIVE SHAFT DAMPER RH |
 |
Remove the front drive shaft damper RH.
- HINT:
- Perform the same procedures as for the front drive shaft damper LH.
| 9.
REMOVE NO. 2 FRONT AXLE OUTBOARD JOINT BOOT CLAMP |
 |
- Using pliers, remove the No. 2 front axle outboard joint boot clamp as shown in the illustration.
| 10.
REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP |
 |
Remove the front axle outboard joint boot clamp.
- HINT:
- Perform the same procedures as for the No. 2 front axle outboard joint boot clamp.
| 11.
REMOVE FRONT AXLE OUTBOARD JOINT BOOT |
 |
Remove the outboard joint boot from the outboard joint shaft.
Remove the grease from the outboard joint.
| 12.
REMOVE FRONT DRIVE SHAFT DUST COVER LH |
 |
- Using SST and a press, remove the drive shaft dust cover LH.
- SST
- 09950-00020
- NOTICE:
- Be careful not to drop the inboard joint assembly.
| 13.
REMOVE FRONT DRIVE SHAFT DUST COVER RH |
 |
- Using a press, remove the drive shaft dust cover RH.
| 14.
REMOVE FRONT DRIVE SHAFT DUST COVER |
 |
- Using SST and a press, remove the drive shaft dust cover.
- SST
- 09950-00020
| 15.
REMOVE FRONT DRIVE SHAFT BEARING |
 |
- Using a snap ring expander, remove the drive shaft hole snap ring.
- Using SST and a press, remove the bearing.
- SST
- 09527-10011
Remove the bearing bracket hole snap ring.
- NOTICE:
- Be careful not to drop the inboard joint assembly.