2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


REMOVE FRONT WHEEL

SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

  1. C067088E04
    Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.


REMOVE FRONT DISC

  1. C132801E01
    Remove the front disc.

    HINT:
    Put matchmarks on the disc and the axle hub.


INSPECT FRONT AXLE HUB BEARING LOOSENESS

  1. C108155
    Using a dial indicator, check for looseness near the center of the axle hub.

    Maximum:
    0.05 mm (0.0020 in.)

    NOTICE:
    Ensure that the dial indicator is set perpendicular to the measurement surface.

    HINT:
    If looseness exceeds the maximum, replace the bearing.


INSPECT FRONT AXLE HUB RUNOUT

  1. C108156
    Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

    Maximum:
    0.05 mm (0.0020 in.)

    NOTICE:
    Ensure that the dial indicator is set perpendicular to the measurement surface.

    HINT:
    If runout exceeds the maximum, replace the axle hub.


INSTALL FRONT DISC

  1. C132801E01
    Align the matchmarks and install the front disc.

    NOTICE:
    When replacing the disc with a new one, select the installation position where the front disc has the minimum runout.


INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

  1. C067088E05
    Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.

    Torque:
    107 N*m{ 1,090 kgf*cm , 79 ft.*lbf }

    NOTICE:
    Do not twist the brake hose when installing the front disc brake caliper assembly.


INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }

← ON-VEHICLE INSPECTION (Jun 2006 – Sep 2006)ON-VEHICLE INSPECTION (from Jun 2009) →