P2769 Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)
Diagnostic trouble codes · Vehicles built from Oct 2006
Also covers:
- P2770 Open in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)
DESCRIPTION
The shift solenoid valve SL is turned ON or OFF by signals from the TCM to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up clutch.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P2769 |
TCM detects a short in the shift solenoid valve SL circuit when the shift solenoid valve SL is operated (2-trip detection logic) |
|
| P2770 |
TCM detects an open in the shift solenoid valve SL circuit when the shift solenoid valve SL is not operated (2-trip detection logic) |
|
If the TCM detects a malfunction, it turns the shift solenoid valve SL OFF.
MONITOR DESCRIPTION
Based on the signals from the throttle position sensor, the air flow meter and the crankshaft position sensor, the TCM sends a signal to the solenoid valve SL to regulate the hydraulic pressure and provide smoother torque converter clutch engagement. The shift solenoid valve SL responds to commands from the TCM. The valve controls the lock-up relay valve to perform the torque-converter lock-up function. If the TCM detects an open or short circuit in the shift solenoid valve SL, it will illuminate the MIL.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL) |
Remove the TCM from the transaxle.

Measure the resistance of the transmission wire.
- Standard resistance:
Tester Connection
Condition
Specified Condition
6 (SL) - Body ground
20°C (68°F)
11 to 15 Ω
|
|
||||
| NG | |
| 2. INSPECT SHIFT SOLENOID VALVE SL (RESISTANCE) |
![]() ![]() |
Remove the shift solenoid valve SL.
Measure the resistance between the solenoid valve terminal and solenoid valve body.
- Standard resistance:
- 11 to 15 Ω at 20°C (68°F)
|
|
||||
| OK | ||
| ||

