2006-2011 Camry Aurion · Service Manual ENGINE

B2271 Ignition Hold Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Jun 2009

DESCRIPTION

This DTC is output when a problem such as an open in the AM2 fuse, an open or short in the wire harness between the fuse and main body ECU (instrument panel junction block assembly), a short in the IG output circuit inside the main body ECU (instrument panel junction block assembly), a short between the main body ECU (instrument panel junction block assembly) and relay, and a short in the relay is detected.
DTC No.
DTC Detection Condition
Trouble Area
B2271
Hold circuit, IG1 relay actuation circuit or IG2 relay actuation circuit inside main body ECU (instrument panel junction block assembly) is open or shorted
  1. AM2 fuse
  2. Main body ECU (instrument panel junction block assembly)
  3. Wire harness or connector

WIRING DIAGRAM

B165251E23

INSPECTION PROCEDURE

HINT:
When the main body ECU (instrument panel junction block assembly) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block assembly) is replaced, perform the registration procedures for the engine immobiliser system.


1. CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

    HINT:
    After all DTCs are cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).

  1. Check for DTCs again.

    OK:
    DTC is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) - BATTERY)
  1. Disconnect the E6 and E7 ECU connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E7-6 (AM1) - Body ground
    Always
    11 to 14 V
    E6-1 (AM2) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) - BATTERY)
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)


← ON-VEHICLE INSPECTION (from Jun 2009)B2272 Ignition 1 Monitor Malfunction (from Jun 2009) →