B2277 Detecting Vehicle Submersion
Diagnostic trouble codes · Vehicles built from Oct 2006
DESCRIPTION
This DTC is output when the submersion circuit monitor inside the main body ECU detects that the vehicle is submerged in water.- HINT:
- When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
- After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2277 |
Submersion circuit monitor inside main body ECU detects that vehicle is submerged in water |
Main body ECU |
INSPECTION PROCEDURE
| 1. CHECK FOR WATER DAMAGE |
Check the main body ECU, peripheral components, and wire harnesses for traces of water.
- OK:
- There are no traces of water.
|
|
||||
| OK | |
| 2. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
- HINT:
- After all DTCs are cleared, check if the trouble occurs again 30 seconds after the engine switch is turned on (IG).
Check for DTCs again.
- OK:
- No DTC is output.
|
|
||||
| OK | ||
| ||
