B2277 Detecting Vehicle Submersion
Diagnostic trouble codes · Vehicles built from Jun 2009
DESCRIPTION
This DTC is output when the submersion circuit monitor inside the main body ECU (instrument panel junction block assembly) detects that the vehicle is submerged in water.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2277 |
Submersion circuit monitor inside main body ECU (instrument panel junction block assembly) detects that vehicle is submerged in water |
Main body ECU (instrument panel junction block assembly) |
INSPECTION PROCEDURE
- HINT:
- When the main body ECU (instrument panel junction block assembly) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
- After the main body ECU (instrument panel junction block assembly) is replaced, perform the registration procedures for the engine immobiliser system.
| 1. CHECK FOR WATER DAMAGE |
Check the main body ECU (instrument panel junction block assembly), peripheral components, and wire harnesses for traces of water.
- OK:
- There are no traces of water.
|
|
||||
| OK | |
| 2. CHECK DTC OUTPUT |
Clear the DTCs (Click here).
- HINT:
- After all DTCs are cleared, check if the trouble occurs again 30 seconds after the engine switch is turned on (IG).
Check for DTCs again.
- OK:
- DTC is not output.
|
|
||||
| OK | ||
| ||
