2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Taillight Relay Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009

DESCRIPTION

The main body ECU receives a signal from the headlight dimmer switch assembly, and turns the taillight relay on.

WIRING DIAGRAM

E212117E01
E197030E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the intelligent tester main switch on.

  1. Select the item below in the ACTIVE TEST and then check that the relay operates.

    Main Body (Main Body ECU): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Taillight Relay
    Taillight relay
    ON / OFF
    -

    OK:
    Taillight relay operates. (Taillights illuminate.)



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. INSPECT FUSE (TAIL)
  1. Remove the TAIL fuse from the instrument panel J/B assembly.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3. INSPECT TAILLIGHT RELAY

  1. A087121E11
    Remove the taillight relay from the instrument panel J/B assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω (When battery voltage is applied to terminals 1 and 2)
    3 - 4
    Below 1 Ω
    10 kΩ or higher (When battery voltage is applied to terminals 1 and 2)



NG
REPLACE TAILLIGHT RELAY
OK


4. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

  1. E143533E01
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    IC-4 - Body ground
    Ignition switch ON, light control switch OFF → TAIL
    Below 1 V → 10 to 14 V
    IC-5 - Body ground
    Ignition switch ON, light control switch OFF → TAIL
    Below 1 V → 10 to 14 V
    IP-8 - Body ground
    Ignition switch ON, light control switch OFF → TAIL
    Below 1 V → 10 to 14 V



OK
REPAIR OR REPLACE HARNESS OR CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - BODY GROUND)
NG


5. CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)

  1. E121505E01
    Disconnect the IA instrument panel J/B assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    IA-1 - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


← Taillight Relay Circuit (Jun 2006 – May 2009)PRECAUTION (from Oct 2006) →