TERMINALS OF ECU
System information · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
| TERMINALS OF ECU |


| Symbols (Terminal No.) |
Terminal Description |
| GND2 (1) |
Skid control ECU ground |
| +BM (2) |
Power supply for motor |
| +BS (3) |
Power supply for solenoid |
| GND1 (4) |
Skid control ECU ground |
| FL+ (5) |
Front left wheel speed sensor input |
| FL- (6) |
Front left wheel speed sensor ground |
| RL+ (7) |
Rear left wheel speed sensor input |
| RR- (8) |
Rear right wheel speed sensor ground |
| FR- (9) |
Front right wheel speed sensor ground |
| FR+ (10) |
Front right wheel speed sensor input |
| CANL (14) |
CAN communication line L |
| BZ (23) |
Buzzer output |
| RL- (27) |
Rear left wheel speed sensor ground |
| IG1 (28) |
ECU power supply |
| RR+ (29) |
Rear right wheel speed sensor input |
| STP1 (30) |
Stop light switch input |
| SP1 (33) |
Speed signal output |
| CANH (35) |
CAN communication line H |
| TS (39) |
Sensor check switch input |
| TERMINAL INSPECTION |
Disconnect the connector and measure the voltage and resistance according to the value(s) in the table below.


- HINT:
- Voltage cannot be measured with the connector connected to the skid control ECU, as the connector is watertight.
Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
GND2 (1) - Body ground
W-B - Body ground
Actuator pump motor ground
Always
Below 1 Ω
+BM (2) - Body ground
B - Body ground
Power supply for motor
Always
10 to 14 V
+BS (3) - Body ground
L - Body ground
Power supply for solenoid
Always
10 to 14 V
GND1 (4) - Body ground
W-B - Body ground
Skid control ECU ground
Always
Below 1 Ω
BZ (23) - Body ground
R - Body ground
Buzzer warning light output
Ignition switch ON, Buzzer does not sound
6 to 10 V
IG1 (28) - Body ground
P - Body ground
IG1 power supply
Ignition switch ON
10 to 14 V
STP1 (30) - Body ground
P - Body ground
Stop light switch input
Stop light switch ON (Brake pedal depressed)
5 to 14 V
STP1 (30) - Body ground
P - Body ground
Stop light switch input
Stop light switch OFF (Brake pedal released)
Below 3 V