2006-2011 Camry Aurion · Service Manual HEATER & AIR CONDITIONING SYSTEM

Heater Control Panel Power Source Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

Battery voltage is supplied to the heater control panel (A/C control assembly) through the A/C No. 2 fuse.

WIRING DIAGRAM

E130413E06

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (IG+ - BODY GROUND)

  1. E124480E14
    Disconnect the connector from the heater control panel.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    F16-8 (IG+) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    F16-8 (IG+) - Body ground
    Ignition switch off
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (GND - BODY GROUND)

  1. E124480E15
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    F16-10 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Heater Control Panel Power Source Circuit (Jun 2006 – Sep 2006)Heater Control Panel Power Source Circuit (from Jun 2009) →