2006-2011 Camry Aurion · Service Manual HEATER & AIR CONDITIONING SYSTEM

LIN Communication Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009

DESCRIPTION

The operation signal of a switch etc. is exchanged between terminal TX+ of the A/C control assembly and terminal LIN1 of the A/C amplifier.

WIRING DIAGRAM

E116883E14

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (A/C CONTROL ASSEMBLY - AIR CONDITIONING AMPLIFIER)

  1. E124480E30
    Disconnect the connector from the A/C control assembly.

  1. E124470E17
    Disconnect the connector from the A/C amplifier.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    E38-37 (LIN1) - F16-4 (TX+)
    Always
    Below 1 Ω
    E38-37 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← LIN Communication Circuit (Jun 2006 – May 2009)ON-VEHICLE INSPECTION (from Jun 2006) →