DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
| CHECK DLC3 |
The vehicle's ECU uses the ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.

Symbol (Terminal No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
10 to 14 V
CANH (6) - CANL (14)
CAN bus line
Ignition switch: LOCK*
54 to 69 Ω
CANH (6) - BAT (16)
HIGH-level CAN bus line
Ignition switch: LOCK*
6 kΩ or higher
CANH (6) - CG (4)
HIGH-level CAN bus line
Ignition switch: LOCK*
200 Ω or higher
CANL (14) - BAT (16)
LOW-level CAN bus line
Ignition switch: LOCK*
6 kΩ or higher
CANL (14) - CG (4)
LOW-level CAN bus line
Ignition switch: LOCK*
200 Ω or higher
- NOTICE:
- *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors.
- HINT:
- Connect the cable of the intelligent tester to the DLC3, turn the ignition switch to the ON position and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
- If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
- If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.