2006-2011 Camry Aurion · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. INSTALL HEATED OXYGEN SENSOR (for Bank 2)

  1. A144643E02
    Using SST, install the heated oxygen sensor.
    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

    NOTICE:
    The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).


2. INSTALL HEATED OXYGEN SENSOR (for Bank 1)

  1. A144644E02
    Using SST, install the heated oxygen sensor.
    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

    NOTICE:
    The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).


3. INSTALL FRONT EXHAUST PIPE ASSEMBLY
  1. Install 2 new gaskets to the exhaust front pipe.

  1. Install the exhaust front pipe to the exhaust manifolds with the 2 nuts and 2 bolts.

    A146046

    Torque:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }


4. INSTALL ENGINE UNDER COVER LH

5. INSTALL ENGINE UNDER COVER RH
← INSPECTION (from Oct 2006)INSTALLATION (from Jun 2009) →