1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here).
2.
REMOVE LAP BELT OUTER ANCHOR COVER
Disengage the 3 claws and remove the lap belt outer anchor cover.
3.
DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt and disconnect the floor end of the front seat outer belt assembly.
4.
REMOVE FRONT DOOR SCUFF PLATE
Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.
5.
REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP
6.
REMOVE REAR DOOR SCUFF PLATE
Disengage the 5 claws and 2 clips, and remove the rear door scuff plate LH.
7.
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP
8.
REMOVE LOWER CENTER PILLAR GARNISH
Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.
9.
REMOVE UPPER CENTER PILLAR GARNISH
Remove the bolt.
Disengage the clip and remove the upper center pillar garnish LH.
10.
DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
11.
REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts and the front shoulder belt anchor adjuster assembly.
12.
REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the connector as shown in the illustration.
HINT:
Tape the screwdriver tip before use.
Remove the 2 bolts and the front seat outer belt assembly.