2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL FRONT DOOR LOCK ASSEMBLY

NOTICE:
  1. When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
  2. Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
  3. Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion to the connection. This may result in a malfunction of the front door lock assembly.

  1. B136432
    Install the front door inside locking cable assembly.

  1. B136431
    Engage the 3 claws.

  1. B136430
    Install the front door lock remote control cable assembly.

  1. Apply MP grease to the sliding parts of the front door lock assembly.

  1. Install a new door lock wiring harness seal to the front door lock assembly.

  1. B136429
    Insert the front door lock open rod into the front door lock assembly, and set it to the front door outside handle frame.

  1. Make sure that the front door lock open rod is securely connected to the front door lock assembly.

  1. Using a "TORX" socket wrench (T30), install the front door lock assembly with the 3 screws.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the connector.


2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER

  1. B136425
    Engage the 2 claws to install the front door outside handle cover to the front door lock cylinder.

  1. B136441
    Install the front door lock cylinder.

    HINT:
    Make sure that the front door lock cylinder rod is inserted into the front door lock assembly.

  1. B136421
    Using a "TORX" socket wrench (T30), install the front door lock cylinder with the screw.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

  1. Install the hole plug.


3. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

  1. B136420
    Install the front door rear lower frame sub-assembly with the bolt.


4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

  1. B136414E01
    Insert the front door glass sub-assembly into the front door panel along the front door glass run as indicated in the order of the arrows in the illustration.

  1. B136412
    Install the front door glass sub-assembly with the 2 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }


5. INSTALL FRONT DOOR SERVICE HOLE COVER
  1. Apply butyl tape to the front door panel.

  1. Pass the front door lock remote control cable and rear door inside locking cable through a new front door service hole cover.

  1. B136411E01
    Install a new service hole cover.

    NOTICE:
    Securely install the front door service hole cover avoiding wrinkles and air bubbles.

  1. Connect each connector and each clamp.


6. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

  1. E129164
    Install the front No. 1 speaker assembly with the 4 bolts.

  1. Connect the connector.


7. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

  1. B136876
    Engage the 4 claws and install the front door inner glass weatherstrip.


8. INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY

  1. B136409
    Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

  1. B136403
    Engage the 2 claws and install the front door inside handle sub-assembly.


9. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
  1. Connect each connector.

  1. B136402
    Engage the front door trim board with the 4 clips of the front door inner glass weatherstrip.

  1. B132840E01
    Engage the 9 clips and install the front door trim board to the front door panel.

  1. Install the 3 screws and clip (A).


10. INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
  1. Connect the connector.

  1. B132839
    Engage the claw and install the courtesy light assembly.


11. INSTALL ASSIST GRIP COVER

  1. B132837
    Engage the 6 claws and install the assist grip cover.


12. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

  1. B132835
    Engage the 3 claws and install the front door inside handle bezel plug.


13. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

  1. B132833
    Engage the 2 clips and install the front door lower frame bracket garnish.

← INSTALLATION (Jun 2006 – Sep 2006)INSTALLATION (from Jun 2009) →