2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL REAR DOOR LOCK ASSEMBLY

NOTICE:
  1. When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
  2. Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
  3. Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion to the connection. This may result in a malfunction of the rear door lock assembly.

  1. B136478
    Install the rear door inside locking cable assembly.

  1. B136477
    Engage the 3 claws.

  1. B136476
    Install the rear door lock remote control cable assembly.

  1. B136475
    Engage the claw.

  1. Apply MP grease to the sliding parts of the rear door lock assembly.

  1. Install a new door lock wiring harness seal to the rear door lock assembly.

  1. B136474
    Insert the rear door lock assembly into the rear door outside handle release plate, and set it to the rear door panel.

  1. Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.

  1. Using a "TORX" socket wrench (T30), install the rear door lock assembly with the 3 screws.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the connector.


2. INSTALL REAR DOOR SERVICE HOLE COVER
  1. Apply butyl tape to the rear door panel.

  1. B149018E01
    Pass the rear door lock remote control cable, rear door inside locking cable and each connector through a new rear door service hole cover.

  1. Install a new rear door service hole cover.

    NOTICE:
    Securely install the rear door service hole cover avoiding wrinkles and air bubbles.

  1. Connect the connector and clamp.


3. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

  1. B136460
    Connect the rear door lock remote control cable and rear door inside locking cable to the rear door inside handle.

  1. B136453
    Engage the 2 claws and install the rear door inside handle sub-assembly.


4. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

  1. B161239
    Engage the 3 claws to install the rear door inner glass weatherstrip.


5. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

  1. B161240
    Engage the claw to install the No. 1 door scuff plate clamp.

  1. Connect each connector.

  1. B136452
    Engage the rear door trim board with the 4 clips of the rear door inner glass weatherstrip.

  1. B136451
    Engage the 7 clips to install the rear door trim board to the rear door panel.

  1. Install the 3 screws.


6. INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
  1. Connect the connector.

  1. B146098
    Engage the claw and install the courtesy light assembly.


7. INSTALL REAR ASH RECEPTACLE ASSEMBLY (w/ Ashtray)

  1. B136442
    Install the rear ash receptacle assembly.


8. INSTALL DOOR ASSIST GRIP COVER

  1. B136448
    Engage the 6 claws and install the door assist grip cover.


9. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

  1. B136444
    Engage the 3 claws to install the rear door inside handle bezel plug.

← INSTALLATION (Oct 2006 – May 2009)COMPONENTS (from Oct 2006) →