INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT REAR DOOR LOCK LH ASSEMBLY |
Remove the rear door lock assembly LH.
Check operation of the door lock motor.

Apply battery voltage and check operation of the door lock motor.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 1
Lock
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 4
Unlock
Check operation of the unlock detection switch.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Measurement Condition
Door Lock Condition
Specified Condition
6 - 9
Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 1
Lock
10 kΩ or higher
6 - 9
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 4
Unlock
Below 1 Ω
| INSPECT REAR DOOR LOCK RH ASSEMBLY |
Remove the rear door lock assembly RH.
Check operation of the door lock motor.

Apply battery voltage and check operation of the door lock motor.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 1
Lock
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 4
Unlock
Check operation of the unlock detection switch.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Measurement Condition
Door Lock Condition
Specified Condition
6 - 9
Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 1
Lock
10 kΩ or higher
6 - 9
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 4
Unlock
Below 1 Ω
