2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

  1. B136443E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.


2. REMOVE DOOR ASSIST GRIP COVER

  1. B149028E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the door assist grip cover.


3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  1. B136451
    Remove the 3 screws.

  1. Using a clip remover, disengage the 7 clips.

  1. B136452
    Raise the rear door trim board to disengage the 4 claws and remove the rear door trim board together with the rear door inner glass weatherstrip.

  1. Disconnect the connector.

  1. B136453
    Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.

  1. B141704
    Disengage the clip as shown in the illustration and remove the No. 1 door scuff plate clamp from the rear door trim board.


4. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

  1. B136456
    Disengage the 3 clips as shown in the illustration and remove the rear door inner glass weatherstrip from the rear door trim board.


5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

  1. B136459
    Disconnect the cables and remove the rear door inside handle sub-assembly.


6. REMOVE REAR DOOR SERVICE HOLE COVER

  1. B149017
    Disconnect the connector.

  1. Remove the rear door service hole cover.

    HINT:
    Remove the remaining tape on the door side.


7. REMOVE REAR DOOR LOCK ASSEMBLY

  1. B136473
    Using a "TORX" socket wrench (T30), remove the 3 screws.

  1. Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

  1. Remove the door lock wiring harness seal from the rear door lock assembly.

  1. B136475
    Using a screwdriver, disengage the claw.

    HINT:
    Tape the screwdriver tip before use.

  1. B136476
    Remove the rear door inside locking cable assembly.

  1. B136477
    Using a screwdriver, disengage the 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. B136478
    Remove the rear door inside locking cable assembly.

← COMPONENTS (from Oct 2006)REMOVAL (Oct 2006 – May 2009) →