2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Room Oscillator Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The certification ECU activates the electrical key oscillators (console and rear seat). The power is supplied from the certification ECU to both the front and rear cabin oscillators. If the smart entry and start system does not operate properly inside the vehicle, check both the electrical key oscillators (console and rear seat) circuits.

WIRING DIAGRAM

B112473E15

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ELECTRICAL KEY OSCILLATOR)

  1. B137966E03
    Disconnect the E58 ECU connector.

  1. Disconnect the oscillator connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    E58-12 (CG5B) - E56 or E99-3 (CLGB)
    Always
    Below 1 Ω
    E58-11 (CLG5) - E56 or E99-1 (CLG3)
    Always
    Below 1 Ω
    E58-14 (CG6B) - N11 or N49-3 (CLGB)
    Always
    Below 1 Ω
    E58-13 (CLG6) - N11 or N49-1 (CLG4)
    Always
    Below 1 Ω
    E58-12 (CG5B) - Body ground
    Always
    10 kΩ or higher
    E58-11 (CLG5) - Body ground
    Always
    10 kΩ or higher
    E58-14 (CG6B) - Body ground
    Always
    10 kΩ or higher
    E58-13 (CLG6) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK AND REPLACE ELECTRICAL KEY OSCILLATOR
  1. Replace the electrical key oscillator.

  1. Check that the entry start and lock-in prevention functions operates normally.

    OK:
    Entry start and lock-in prevention functions operates normally.



OK
END (ELECTRICAL KEY OSCILLATOR IS DEFECTIVE)
NG


3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Reconnect the oscillator and the ECU connectors.

  1. Connect the intelligent tester to the DLC3.B150920E01

  1. Turn the engine switch on (IG).

  1. Following the display on the tester, select "ACTIVE TEST".

    Entry and Start (Certification ECU): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Fr Transmitter
    Indoor electrical key oscillator (console)
    ON/OFF
    -
    Rr Transmitter
    Indoor electrical key oscillator (rear seat)
    ON/OFF
    -

  1. B137963E16
    Measure the frequency according to the value(s) in the table below.

    Standard:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    E58-12 (CG5B) - E58-11 (CLG5)
    During ACTIVE TEST
    Frequency is generated (higher than 0 Hz)
    E58-14 (CG6B) - E58-13 (CLG6)
    During ACTIVE TEST
    Frequency is generated (higher than 0 Hz)



NG
REPLACE CERTIFICATION ECU
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Room Oscillator Circuit (Oct 2006 – May 2009)Luggage Compartment Door Open Switch Circuit (Oct 2006 – May 2009) →