2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Luggage Compartment Door Open Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

If the certification ECU detects that the luggage compartment door opener outer switch is pressed when the driver is carrying the electrical key or when the electrical key is left in the luggage compartment door, the certification ECU sends a luggage compartment door open motor drive request signal to the main body ECU.

WIRING DIAGRAM

B112474E15

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - LUGGAGE COMPARTMENT OPEN SWITCH)

  1. B137968E03
    Disconnect the E58 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    E58-7 (TSW5) - Body ground
    Luggage compartment door opener switch not pushed
    10 kΩ or higher
    Luggage compartment door opener switch pushed
    Below 1 Ω



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
NG


2. INSPECT LUGGAGE COMPARTMENT OPENER OUTER SWITCH
  1. Disconnect the switch connector.

  1. B164380E01
    for 2GR-FE:
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Luggage compartment door opener outer switch not pushed (OFF)
      10 kΩ or higher
      Luggage compartment door opener outer switch pushed (ON)
      Below 1 Ω

  1. for 2AZ-FE:B219269E02

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 - 8
      Luggage compartment door opener outer switch not pushed (OFF)
      10 kΩ or higher
      Luggage compartment door opener outer switch pushed (ON)
      Below 1 Ω



NG
REPLACE LUGGAGE COMPARTMENT OPENER OUTER SWITCH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (LUGGAGE COMPARTMENT DOOR OPENER OUTER SWITCH - BODY GROUND)

  1. B164379E01
    for 2GR-FE:
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      S9-1 - Body ground
      Always
      Below 1 Ω

  1. for 2AZ-FE:

    1. B219264E02
      Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      S22-8 - Body ground
      Always
      Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (LUGGAGE COMPARTMENT DOOR OPENER OUTER SWITCH - BODY GROUND)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (ECU - LUGGAGE COMPARTMENT DOOR OPENER OUTER SWITCH)


← Luggage Compartment Door Open Switch Circuit (Oct 2006 – May 2009)Certification ECU Power Source Circuit (Oct 2006 – May 2009) →