2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jun 2006


INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY

E194795E01
  1. Check the windshield wiper switch assembly.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Front wiper switch (for LHD):
      Tester Connection
      Switch Connection
      Specified Condition
      E20-3 (+1) - E20-2 (+B)
      MIST
      Below 1 Ω
      LO
      E20-3 (+1) - E20-1 (+S)
      OFF
      E20-3 (+1) - E20-1 (+S)
      INT
      E20-2 (+B) - E20-4 (+2)
      HI
      Front wiper switch (for RHD):
      Tester Connection
      Switch Condition
      Specified Condition
      E20-2 (+1) - E20-3 (+B)
      MIST
      Below 1 Ω
      LO
      E20-2 (+1) - E20-4 (+S)
      OFF
      E20-2 (+1) - E20-4 (+S)
      INT
      E20-6 (AUTO) - E20-5 (E) (*1)
      AUTO
      E20-3 (+B) - E20-1 (+2)
      HI
      E20-7 (VR2) - E20-8 (VR1) (*1)
      Adjusting right changed from (+) side to (-) side
      0 to 2.7 kΩ

      *1: with Rain Sensor

      Standard resistance:
      Front washer switch (for LHD):
      Tester Connection
      Switch Condition
      Specified Condition
      E19-2 (EW) - E19-3 (WF)
      ON
      Below 1 Ω
      OFF
      10 kΩ or higher
      Front washer switch (for RHD):
      Tester Connection
      Switch Condition
      Specified Condition
      E19-1 (WF) - E19-2 (EW)
      ON
      Below 1 Ω
      OFF
      10 kΩ or higher

      If the result is not specified, replace the switch assembly.

  1. Check the front washer operation (for LHD).

    1. Turn the wiper switch OFF.

    2. Connect the battery's positive (+) lead to terminal E20-2 (+B) and the negative (-) lead to terminals E20-1 (+S) and E19-2 (EW).

    3. Connect the volt meter's positive (+) lead to E20-3 (+1) and the negative (-) lead to terminal E19-2 (EW).

    4. Turn the washer switch ON and OFF, and check the voltage between terminals E20-3 (+1) and E19-2 (EW).

      OK:
      Refer to the illustration below.

  1. Check the front washer operation (for RHD).

    1. Turn the wiper switch OFF.

    2. Connect the battery's positive (+) lead to terminal E20-3 (+B) and the negative (-) lead to terminals E20-4 (+S) and E19-2 (EW).

    3. Connect the volt meter's positive (+) lead to E20-2 (+1) and the negative (-) lead to terminal E19-2 (EW).

    4. Turn the washer switch ON and OFF, and check the voltage between terminals E20-2 (+1) and E19-2 (EW).

      E125344E05
      If the result is not as specified, replace the switch assembly.

← REMOVAL (from Jun 2009)INSTALLATION (Jun 2006 – Sep 2006) →