The main body ECU stores trouble codes when trouble occurs on the vehicle. The diagnostic system allows for reading of the trouble codes from the DLC3. Use the intelligent tester to check and solve the problem.
CHECK DLC3
The main body ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
Symbols (Terminal No.)
Terminal Description
Condition
Specified condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
11 to 14 V
CANH (6) - CANL (14)
CAN bus line
Ignition switch off*
54 to 69 Ω
CANH (6) - CG (4)
HIGH-level CAN bus line
Ignition switch off*
200 Ω or higher
CANL (14) - CG (4)
LOW-level CAN bus line
Ignition switch off*
200 Ω or higher
CANH (6) - BAT (16)
HIGH-level CAN bus line
Ignition switch off*
6 kΩ or higher
CANL (14) - BAT (16)
LOW-level CAN bus line
Ignition switch off*
6 kΩ or higher
NOTICE:
*: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors.
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
Connect the cable of the intelligent tester to the DLC3, turn the ignition switch to the ON position and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
If communication is still impossible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.