2006-2011 Camry Aurion · Service Manual SECURITIES

Engine Hood Courtesy Switch Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

The engine hood courtesy switch is installed together with the hood lock. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.

WIRING DIAGRAM

B144359E01

INSPECTION PROCEDURE


1. INSPECT ENGINE HOOD COURTESY SWITCH

  1. B144360E01
    Remove the courtesy switch from the hood lock.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 - 2
    Free (ON)
    Below 1 Ω
    Pushed (OFF)
    10 kΩ or higher



NG
REPLACE ENGINE HOOD COURTESY SWITCH
OK


2. CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND)

  1. B144361E01
    Disconnect the A5 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    A5-1 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE HOOD COURTESY SWITCH)

  1. B144362E01
    Disconnect the E59 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    (Symbol) Tester Connection
    Specified Condition
    HSW (E59-24) - (A5-2)
    Below 1 Ω
    HSW (E59-24) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← DATA LIST / ACTIVE TEST (from Oct 2006)Horn Circuit (Oct 2006 – May 2009) →