2006-2011 Camry Aurion · Service Manual SECURITIES

Security Horn Circuit

Circuit diagnosis · Vehicles built from Jun 2006

DESCRIPTION

When the theft deterrent system is changed from the armed state to the alarm sounding state, the main body ECU can control the security horn.

WIRING DIAGRAM

B139446E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the intelligent tester main switch on.

  1. Select the item below in the Active Test and then check that the horn sounds.

    Main Body (Main Body ECU): 
    Item
    Test Details
    Diagnostic Note
    Security Horn
    Security horn ON/OFF
    -

    OK:
    The security horn sounds or stops correctly when operating it through the intelligent tester.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2. INSPECT SECURITY HORN ASSEMBLY

  1. B144348
    Remove the security horn assembly.

  1. Check operation of the horn.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Horn sounds
    Battery negative (-) → Horn body



NG
REPAIR OR REPLACE SECURITY HORN ASSEMBLY
OK


3. CHECK HARNESS AND CONNECTOR (ENGINE ROOM J/B - SECURITY HORN ASSEMBLY)

  1. B139441E01
    Disconnect the 1A J/B connector and the A23 horn connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Terminal Connection
    Specified Condition
    1A-5 - A23-1
    Below 1 Ω
    1A-5 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE ROOM J/B)

  1. B139442E01
    Disconnect the E9 ECU connector and 1D J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Terminal Connection)
    Specified Condition
    SH (E9-6) - (1D-11)
    Below 1 Ω
    SH (E9-6) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. CHECK HARNESS AND CONNECTOR (ENGINE ROOM J/B - BATTERY)

  1. B074501E16
    Disconnect the 1G J/B connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Terminal Connection
    Specified Condition
    1G-1 - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ENGINE ROOM JUNCTION BLOCK ASSEMBLY


← Horn Circuit (from Jun 2009)Ignition Switch Circuit (from Jun 2006) →