INITIALIZATION
Troubleshooting · Vehicles built from Oct 2006
- HINT:
- In vehicles equipped with the smart entry and start system function, the starting function may not operate after recharging or while jump-starting a discharged battery. This condition is most common if the battery voltage drops below 9 V. The following procedure has been developed to address this condition.
| INITIALIZATION PROCEDURE |
![]() ![]() |
Confirm that the short pin is installed.
- HINT:
- If the short pin is not installed, install it at this time.
Move the shift lever to the P position.
Turn the engine switch off.
Open the driver's door.
- HINT:
- Opening the driver's door will start an initialization process between the steering lock ECU and the engine room J/B.
Depress the brake pedal.
Press the "START STOP" switch.

