REMOVAL
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for HID Headlight) |
|
| 2.
REMOVE COOL AIR INTAKE DUCT SEAL
|
 |
- Remove the 7 clips and cool air intake duct seal.
| 3.
REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)
|
 |
- Put protective tape around the front bumper assembly.
- Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 8 screws, 3 clips and 2 radiator grille protectors.
- Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedure for the RH side and LH side.
Remove the front bumper assembly.
| 4.
REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)
|
 |
- Put protective tape around the front bumper assembly.
- Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 8 screws, 3 clips and 2 radiator grille protectors.
- Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedure for the RH side and LH side.
Disconnect each connector, and then remove the front bumper assembly.
| 5.
REMOVE FRONT BUMPER ASSEMBLY (w/ Clearance Sonar System)
|
 |
- Put protective tape around the front bumper assembly.
- Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 8 screws, 3 clips and 2 radiator grille protectors.
- Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedure for the RH side and LH side.
Disconnect each connector, and then remove the front bumper assembly.
| 6.
REMOVE FRONT BUMPER ASSEMBLY (w/ Headlight Cleaner System)
|
 |
- Put protective tape around the front bumper assembly.
- Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 8 screws, 3 clips and 2 radiator grille protectors.
- Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedure for the RH side and LH side.
Disconnect each connector.
- Disconnect the headlight cleaner washer hose, and then remove the front bumper assembly.
| 7.
REMOVE HEADLIGHT ASSEMBLY |
 |
- Remove the bolt and 3 screws.
Disconnect the connectors and remove the headlight assembly.